beautypg.com

Table 2-2. controller panel mounting, Figure 2-3. single or multiple panel mounting – Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller Instruction Manual User Manual

Page 43

background image

Table 2-2. Controller Panel Mounting

Step

Procedure

See Figure

1

Ensure the through-case shipping bolt is removed as described in Table 2-1. Figure 2-1

2

Slip the trim collar (mounting frame) over the rear of the case and slide it
forward to the front of the case.

Figure 2-3
Figure 2-4

For Single Mounted Case(s)

3a

Slide the controller through the panel opening.

Figure 2-3

4a

Support the weight of the case and attach the top and bottom mounting
brackets. Tighten the bracket screws.

Figure 2-4

For Multiple Mounted Cases

3b

Slide the controller through the panel opening.

Figure 2-3

4b Install MicroMod self-adhesive pads at rear of cases and spacer bars

between the cases. Two pads, one on top of the other, are needed at the
rear of the cases. Start the installation from the right (when facing the
panel), installing the spacers as each case is added. After each case is
positioned in place, install and tighten the top and bottom mounting
brackets. Each case must be tight against the previous case.

Figure 2-5

Figure 2-4

Note

Spacers are not required on the outside of the

right and left cases.

Figure 2-3. Single or Multiple Panel Mounting

53MC5000 Process Control Station

2-4