Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller Instruction Manual User Manual
Page 108
3.13.1.5 HHC MEMORY MODULE ASSEMBLY TRANSFER
The procedure to save or load the controller database and/or calibration constants using the HHC
with memory module (part number 698B182U02) is as follows:
1.
Insert the memory module containing the desired database in the HHC. The memory module
is inserted by placing it into the recess at the back of the HHC with the memory module label
facing outward and up, then sliding it down until it is firmly seated. When loading a database
to the controller, verify that the write protect switch (when present) on the memory module
has been pushed to its outside position. When saving a controller database to the memory
module, the write protect switch must be toward the inside.
2.
To initiate the
TRANSFER operation, press T at the command entry point. The following
menu appears:
MEMORY TRANSFER
F1-TO CONTROLLER
F2-FROM CONTROLLER
3.
Press either
F1 or F2 to select the desired operation. Pressing CTRL C aborts the operation.
Depending on which selection is made, one of the following two menus is displayed:
1. If
F1 (TO CONTROLLER) is selected , the following menu appears:
F1-CALIBRATE
F2-DATABASE
F3-PROGRAM
Based on the selection made from this menu, one of the following operations can occur:
•
F1-CALIBRATE: This selection copies the calibration
values of the standard analog inputs and outputs to the
controller. These are values that were previously
saved to the memory module with a memory transfer
from the controller. This transfer takes approximately 1
second.
•
F2-DATABASE: This selection copies the database,
less the calibration values, and the assigned controller
address to the controller. This transfer takes approxi-
mately 12 seconds.
•
F3-PROGRAM: This selection copies the F-TRAN pro-
grams and F-CIM module sequences to the controller.
This transfer takes approximately 20 seconds.
2.
If
F2 (FROM CONTROLLER) is selected, the following menu appears:
F2-DATABASE
F3-PROGRAM
Section 3. Product Description
3-25