Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller Instruction Manual - Manual (Page 27)

Table 1-1. 53MC5000 Process Control Station Specifications
Item Specification(s)
Lithium battery:
MicroMod Automation part number
Manufacturer
Manufacturer’s part number
Battery type
Voltage
Capacity
Storage temperature
Operating temperature
Sealing
167B024U01
Eagel Picher Industries, Inc.
Box 130 Bethel Road
Seneca, MO 64865
LTC-7P
Inorganic, liquid lithium thionyl chloride.
3.5
750 mAh
150
°
C (302
°
F).
-40
°
to 125
°
C (-40
°
to 257
°
F).
Hermetic, non-venting.
WARNING
REPLACE BATTERY WITH EAGLE PICHER P/N LTC-7P ONLY. USE OF
ANOTHER BATTERY MAY PRESENT A RISK OF FIRE OR EXPLOSION.
CAUTION
BATTERY MAY EXPLODE IF MISTREATED. DO NOT RECHARGE,
DISASSEMBLE, OR DISPOSE OF IN FIRE. DISPOSE OF USED
BATTERIES IN ACCORDANCE WITH FEDERAL, STATE, AND LOCAL
CODE REQUIREMENTS FOR DISPOSAL OF HAZARDOUS MATERIALS.
Replacement procedure The LTC-7P battery is short circuit protected for wave
soldering. Care should be taken to avoid short circuiting
the battery during installation. No special handling
procedures are required for removal of used batteries.
4 of 4
Section 1. Introduction
1-13