Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller Instruction Manual - Manual (Page 104)

3.13 KEYPAD ALTERNATIVES
There are six alternative methods other than the faceplate push buttons for accessing and changing
database parameters. All six methods to display and/or alter database parameters are listed as
follows:
1. Using a personal computer running the MC5FIG.EXE configuration program that is sup-
plied as part of the 53HC3300 software package. This procedure is included in the In-
struction Bulletin (IB 53HC3300) with the software.
2. Using a personal computer running the configuration program that is supplied as part of
the 53MT6000 software package. This procedure is included in the Instruction Bulletin
(IB 53MT6000) with the software.
3. Using an SUPERVISOR-PC with configuration software. This procedure is pro-
vided in the SUPERVISOR-PC Instruction Bulletin (IB 53SU5000).
4. Using the Hand Held Configurer connected to the configuration port mini-DIN plug
on the front panel of the instrument.
5. Using an ASCII RS-232 terminal or a PC terminal emulator application connected to the
configuration port mini-DIN plug on the front panel of the instrument (Refer to Section
3.13.2).
6. Using the remote keypad. (See Appendix C, Remote Keypad.)
Figure 3-6 illustrates the Hand Held Configurer and personal computer mini-DIN plug cables neces-
sary to configure an instrument using alternative methods 1 through 5 described above. The
personal computer cable type (9 pin or 25 pin) is dependent upon the communications port connec-
tor.
3.13.1 USING THE HAND HELD CONFIGURER
The Hand Held Configurer (HHC) is a portable terminal designed to interface with the instrument
through the configuration port that is located behind the pull-down door on the faceplate of the
instrument (see Figure 3-1).
The HHC is available in two versions:
1. A Standard HHC with capabilities to display or alter specifically addressed datapoints in
the controller database. The part number to order this HHC is 698B182U01.
2. An HHC with memory function capabilities to save the entire database of a controller
onto a removable memory module assembly or load a controller database from an HHC
memory module assembly. The part number to order this HHC is 698B182U02.
Section 3. Product Description
3-21