Metrohm 732 IC Detector - Manual (Page 76)

4.1 Operating sequences
732 IC Detector / 733 IC Separation Center
69
4.1.3 Flow chart for putting into operation
The following flow diagram shows how the IC system can be put back
into operation after a separating column has been removed and all de-
vices have been switched off (shutdown, see section 5.2.4). A require-
ment is that the installation (section 2.1) is complete and the basic set-
tings (section 4.1.2) have been made. You will find further information in
the sections mentioned.
Suppressor? Suppressor?
yes yes
no no
Preparing regeneration solution Preparing regeneration solution
Preparing rinsing solution Preparing rinsing solution
Switching on auxiliary pump Switching on auxiliary pump sect. 2.8.6 sect. 2.8.6
End End
Preparing eluent Preparing eluent sect. 5.1.3 sect. 5.1.3
Preparing standards and samples Preparing standards and samples
Switching on external devices Switching on external devices
Switching on 709 IC Pump Switching on 709 IC Pump
Switching on 732 IC Detector Switching on 732 IC Detector sect. 2.4.4 sect. 2.4.4
Method? Method?
no no
yes yes
New New
method? method?
Setting parameters Setting parameters sect. 4.5 sect. 4.5
Developing a method Developing a method sect. 4.7.4 sect. 4.7.4
Recalling method Recalling method sect. 4.7.4 sect. 4.7.4
no no
yes yes
Start Start
Rinsing IC system with eluent Rinsing IC system with eluent
Stable Stable
baseline? baseline?
no no
yes yes
Installing separating column Installing separating column sect. 2.8 sect. 2.8