Metrohm 732 IC Detector - Manual (Page 100)

4.4 Basic settings
732 IC Detector / 733 IC Separation Center
93
>CONFIG/aux/beep
repeat time 60 s
5 … 999 s, off
Repeat time for beep
This inquiry appears only with " status = on ".
The three beeps with error messages are re-
peated each time the inputted time has elapsed
until the error message is confirmed with
.
off No repeat
(press ).
>CONFIG
>CONFIG/RS settings Settings for RS232 interface
For further details on the RS232 interface, see section 6.1.
>CONFIG/RS settings
baud rate: 9600
9600, 4800, 2400,
1200, 600, 300
Data transmission rate (baud rate)
Data transmission rate in bit/s
>CONFIG/RS settings
data bit: 8
7, 8
Data bits
>CONFIG/RS settings
stop bit: 1
1, 2
Stop bits
>CONFIG/RS settings
parity: none
none, odd, even
Parity
none Parity is not checked.
odd Odd parity.
even Even parity.
>CONFIG/RS settings
handshake: HWs
HWs, HWf,
SWchar, SWline, none
Handshake
HWs Reduced hardware handshake.
HWf Full hardware handshake.
SWchar Software handshake with character stop.
SWline Software handshake with line stop
none No handshake.
For detailed information on the handshake, see section
6.1.8.
>CONFIG/RS settings
RS control: on
on, off
Control via RS232 interface
on Data receipt via RS232 interface
switched on.
off Data receipt via RS232 interface
switched off (no external control via
RS232 possible).