Metrohm 732 IC Detector - Manual (Page 165)

5 Notes – Maintenance – Faults
732 IC Detector / 733 IC Separation Center
158
• Press key to open the following diagnostic menu:
>diag/EEPROM initial.
block: USER
ь ь ь ь ь ь ь ь ь ь ь ь
>diag/EEPROM initial.
block: CONFIG
ь ь
>diag/EEPROM initial.
block: INFO
ь ь
>diag/EEPROM initial.
block: SETUP
ь ь
>diag/EEPROM initial.
block: ASSEMBLY
ь ь
>diag/EEPROM initial.
block: EVENT
ь ь
>diag/EEPROM initial.
block: METHOD
ь ь
>diag/EEPROM initial.
block: ALL
ь ь ь ь ь ь ь ь ь ь ь ь ь ь ь ь 1)
Set config parameters with default values. Ã
Set info parameters with default values. Ã
Set setup parameters with default values. Ã
Set assembly parameters with default values. Ã
Set event parameters with default values. Ã
Delete method memory. Ã
Delete device number. Ã
Set instrument adjustment with default values. Ã
Pressing the key selects the submenus in turn. The individual initializa-tion alternatives are accessed using the key, exit is with the key.
The table shows which parts of the data memory are affected by the correspondinginitialization alternatives.• If need be, press the key repeatedly until the desired
tion alternatives are accessed using the key, exit is with the
key.
The table shows which parts of the data memory are affected by the corresponding
initialization alternatives.
• If need be, press the
initialization alternative appears (such as “USER“)
>diag/EEPROM initial.
block: USER
•
After the initialization has run automatically, the instrument quits the diagnostic menu
and runs a power on reset.
1) Care: This initialization alternative is reserved for the service engineer!