Metrohm 732 IC Detector - Manual (Page 131)

4 Operation
732 IC Detector / 733 IC Separation Center
124
4.8.3 key
REPORT
2
The key is used for the output of reports on an external
printer or PC connected to the RS232 interface.
The key opens the following inquiry:
XXXXXX µµS/cm XXXX min
report: all
all, config, event,
method, method list,
param, program, pump
Selection of the report
Selection of the report which should be outputted:
all All reports in the order " config, event,
method, method list, pump "
config Configuration report (parameters of the
key)
event Event report (parameters of the
key)
method Method report (comprises method name,
parameter and program report)
method Method list (details of stored
list methods)
param Parameter report (parameters of the
key)
program Program report (parameters of the
key)
pump Report of the pump parameters
Example of "config" report
Configuration for 732 IC Detector with attached Seiko printer and 733.0010
IC Separation Center with 1 injection valve
CONFIG
>CONFIG/detector
thermostat: 35 °C
'zero' unit:
µ S/cm
cell constant 16.7 /cm
>CONFIG/printer
id.1 PRP-X100
id.2 drinking water
print header: once
date&time: on
send to: Seiko
>CONFIG/print meas.value
print crit.: time
time interval 300.0 s
stop time 60 min
date&time: off
>CONFIG/auxiliaries
run number 0
number of cycles 1
>CONFIG/aux/event
enabled in program: off
date 1995-10-10
time 11:38:20
dialog: english
device label
program 732.0012
>CONFIG/aux/beeper
status: on
repeat time 60 s
>CONFIG/RS settings
baud rate: 9600
data bit: 8
stop bit: 1
parity: none
handshake: HWs
control via RS: on
>CONFIG/RS settings 709
baud rate: 9600
>CONFIG/733 IC Sep.Cent.
valve A
control: no restriction
>CONFIG/733/valve A
status inject
trigger: inject
--------------