beautypg.com

2 setting up the instruments, Packaging, Check – Metrohm 732 IC Detector User Manual

Page 19: Location, Arrangement of the instruments

background image

2 Installation

732 IC Detector / 733 IC Separation Center

12

2.2

Setting up the instruments

2.2.1

Packaging

The 732 IC Detector and 733 IC Separation Center are supplied

together with the separately packed accessories in special packagings

containing shock-absorbing foam linings designed to provide excellent

protection. The actual instruments are packed in an evacuated

polyethylene bag to prevent the ingress of dust. Please store all these

special packagings as only they assure transport of the instruments

free from damage.

2.2.2

Check

After receipt, immediately check whether the shipment is complete and

has arrived without damage (compare with delivery note and list of ac-

cessories in section 7.2). In the case of transport damage, see instruc-

tions in section 7.4.1 "Warranty".

2.2.3

Location

Position the instruments in the laboratory at a location convenient for

operation, free from vibrations and protected against a corrosive at-

mosphere and contamination by chemicals. The same applies to all

other components of the IC system.

To avoid disturbing temperature influences on the insulated column

compartment, the entire system including pump and eluent reservoir

must be protected against direct sunlight.

2.2.4

Arrangement of the instruments

In one-channel operation, the 709 IC Pump, 733 IC Separation Center

and 732 IC Detector are best stacked on top of one another in this or-

der.
In two-channel operation (2.733.0X20 IC Separation Center), the opti-

mum arrangement (1, 2 or 3 towers) depends on the laboratory space

available. However, the 709 IC Pumps should be set up at the very

bottom and the 732 IC Detectors at the very top.

To ensure that the arrangement of pumps and detectors for the two

channels A and B is clearly apparent in two-channel operation, it is

advantageous to mark the instruments. The 6.2248.000 Magnetic

plate is enclosed with the 732 IC Detector for this purpose. It can be

cut to the desired size, labeled (e.g. with "A" or "B") and affixed to the

appropriate instrument.