Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 657)

View DHCPv6 snooping status and ports
To see DHCPv6 snooping status and ports, enter the show ipv6 dhcp6 snooping vlan command. The
following is an example of the output.
Brocade# show ipv6 dhcp6 snooping vlan
IP dhcpv6 snooping enabled on 1 VLANS(s):
VLAN:10
Brocade# show ipv6 dhcp6 snooping vlan
IP dhcpv6 snooping VLAN 10: Enabled
Trusted Ports: ethe 1/1/1
Untrusted Ports: ethe 1/1/2 ethe 1/1/3
Syntax: show ipv6 dhcp6 snooping vlan vlan-name
View DHCPv6 snooping binding database
To see DHCPv6 snooping binding database, enter the show ipv6 dhcp6 snooping info command.
The following is an example of the output.
Brocade# show ipv6 dhcp6 snooping info
IP dhcpv6 snooping enabled on 1 VLANS(s):
IPv6 Address LinkLayer-Addr Age VRF
2002::24 0000.0343.0958 259198 0
2002::4a 7c00.030c.ccc9 259198 0
Syntax: show ipv6 dhcp6 snooping info
Application and routing protocol specific VRF show commands
The following protocol show commands accept a VRF parameter to display VRF specific application,
protocol configuration, and protocol state information.
• Default VRF
‐ Show ip route
‐ Show ip ospf neighbor
‐ Show ip rip interface
‐ Show ip bgp summary
• User defined VRF
‐ Show ip route vrf
‐ Show ip ospf vrf neighbor
‐ Show ip rip vrf interface
‐ Show ip bgp vrf summary
Multi-VRF basic configuration example
This section describes a basic Multi-VRF configuration.
View DHCPv6 snooping status and ports
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 657
53-1003087-04