Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 348)

Displaying OSPFv3 information
You can display the information for the following OSPFv3 parameters:
• Areas
• Link state databases
• Interfaces
• Memory usage
• Neighbors
• Redistributed routes
• Routes
• SPF
• Virtual links
• Virtual neighbors
• IPsec
• key-add-remove interval
General OSPFv3 configuration information
To indicate whether the Brocade device is operating as ASBR or not, enter the following command at
any CLI level.
device#show ipv6 ospf
OSPFv3 Process number 0 with Router ID 0xc0a862d5(192.168.98.213)
Running 0 days 2 hours 55 minutes 36 seconds
Number of AS scoped LSAs is 4
Sum of AS scoped LSAs Checksum is 18565
External LSA Limit is 250000
Database Overflow Interval is 10
Database Overflow State is NOT OVERFLOWED
Route calculation executed 15 times
Pending outgoing LSA count 0
Authentication key rollover interval 300 seconds
Number of areas in this router is 3
Router is operating as ABR
Router is operating as ASBR, Redistribute: CONNECTED RIP
High Priority Message Queue Full count: 0
Graceful restart helper is enabled, strict lsa checking is disabled
Nonstop Routing is disabled
The output of the show ipv6 ospf command indicates if the Brocade device is operating as ASBR. If
the device is not operating as ASBR, then there is no information about redistribution in the output.
Displaying OSPFv3 area information
To display global OSPFv3 area information for the device, enter the following command at any CLI
level.
device# show ipv6 ospf area 400
Area 400:
Authentication: Not Configured
Active interface(s)attached to this area: None
Inactive interface(s)attached to this area: ve 20 ve 30
Number of Area scoped LSAs is 311
Sum of Area LSAs Checksum is 9e8fff
Statistics of Area 400:
SPF algorithm executed 10 times
SPF last updated: 5920 sec ago
Current SPF node count: 1
Displaying OSPFv3 information
348 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04