beautypg.com

Clearing ripng routes from ipv6 route table, Displaying ripng information, Displaying ripng configuration – Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide User Manual

Page 239

background image

Clearing RIPng routes from IPv6 route table

To clear all RIPng routes from the RIPng route table and the IPv6 main route table and reset the routes,
enter the following command at the Privileged EXEC level or any of the Config levels of the CLI.

device# clear ipv6 rip route

Syntax: clear ipv6 rip route

Displaying RIPng information

You can display the following RIPng information:

• RIPng configuration
• RIPng routing table

Displaying RIPng configuration

To display RIPng configuration information, enter the show ipv6 rip command at any CLI level.

device# show ipv6 rip

IPv6 rip enabled, port 521

Administrative distance is 120

Updates every 30 seconds, expire after 180

Holddown lasts 180 seconds, garbage collect after 120

Split horizon is on; poison reverse is off

Default routes are not generated

Periodic updates 5022, trigger updates 10

Distribute List, Inbound : Not set

Distribute List, Outbound : Not set

Redistribute: CONNECTED

Syntax: show ipv6 rip

show ipv6 rip output descriptions

TABLE 53

Field

Description

IPv6 RIP status/port

The status of RIPng on the device. Possible status is "enabled" or "disabled."

The UDP port number over which RIPng is enabled.

Administrative distance

The setting of the administrative distance for RIPng.

Updates/expiration

The settings of the RIPng update and timeout timers.

Holddown/garbage collection

The settings of the RIPng hold-down and garbage-collection timers.

Split horizon/poison reverse

The status of the RIPng split horizon and poison reverse features. Possible status
is "on" or "off."

Default routes

The status of RIPng default routes.

Clearing RIPng routes from IPv6 route table

FastIron Ethernet Switch Layer 3 Routing Configuration Guide

239

53-1003087-04