beautypg.com

Displaying ipv6 ospfv3 interface information – Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide User Manual

Page 356

background image

show ipv6 interface output descriptions

TABLE 74

Field

Description

Type Codes

Shows the routing protocol enabled on the interface. The routing protocol can be one of the
following:

• R - RIP
• O - OSPF

Interface

Shows the type, slot, and port number of the interface.

Stat/Prot

Shows the status of the link and the protocol for the interface. The status can be one of the
following:

• Up
• Down

IGPs

Shows the type of the Interior Gateway Protocols (IGPs) enabled on the interface.

IPv6 Address Shows the link local IPv6 address configured for the interface.

VRF

Specifies the VRF to which the interface belongs.

Displaying IPv6 OSPFv3 interface information

IPv6 Interface information can be displayed in either a brief or full mode. The following sections
describe the command to display these modes and the resulting output:

• Displaying IPv6 OSPFv3 Interface Information in Brief Mode
• Displaying IPv6 OSPFv3 Interface Information in Full Mode

Displaying IPv6 OSPFv3 interface information in brief mode

You can use the following command to display a summary of IPv6 Interface information.

device# show ipv6 ospf interface brief

Interface Area Status Type Cost State Nbrs (F/C)

eth 1/1 0 up BCST 1 DROther 1/1

loopback 1 0 up BCST 1 Loopback 0/0

Syntax: show ipv6 ospf interface brief

show ipv6 ospf interface brief output descriptions

TABLE 75

This field Displays

Interface

The interface type, and the port number or number of the interface.

Area

The OSPF area configured on the interface.

Displaying IPv6 OSPFv3 interface information

356

FastIron Ethernet Switch Layer 3 Routing Configuration Guide

53-1003087-04