Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 308)

The extensive option displays the LSAs in decrypted format.
NOTE
You cannot use the extensive option in combination with other display options. The entire database is
displayed.
The link-state-id ip-addr parameter displays the External LSAs for the LSA source specified by ip-
addr.
The router-id ip-addr parameter shows the External LSAs for the specified OSPF router.
The sequence-number num(Hex) parameter displays the External LSA entries for the specified
hexadecimal LSA sequence number.
show ip ospf database external-link-state output descriptions TABLE 64
This field Displays
Index ID of the entry
Age The age of the LSA in seconds.
LS ID The ID of the link-state advertisement from which the device learned this route.
Router The router IP address.
Netmask The subnet mask of the network.
Metric The cost (value) of the route
Flag State information for the route entry. This information is used by Brocade technical support.
SyncState This field indicates whether the synchronization is complete or not.
Displaying OSPF database-summary information
To display database-summary information, enter the following command at any CLI level.
device#show ip ospf database database-summary
Area ID Router Network Sum-Net Sum-ASBR NSSA-Ext Opq-Area Subtotal
0.0.0.0 104 184 19 42 0 0 349
AS External 308
Total 104 184 19 42 0 0
657
Syntax: show ip ospf database database-summary
show ip ospf database database-summary output descriptions TABLE 65
This field Displays
Area ID The area number.
Router The number of router link state advertisements in that area.
Displaying OSPF database-summary information
308 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04