Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 272)

FIGURE 25 Redistributing OSPF and static routes to RIP routes
You also have the option of specifying import of just RIP, OSPF, BGP4, or static routes, as well as
specifying that only routes for a specific network or with a specific cost (metric) be imported, as shown
in the command syntax below.
Syntax: [no] redistribute { bgp | connected | rip | static [ route-map map-name ] }
NOTE
Prior to software release 04.1.00, the redistribution command is used instead of redistribute .
For example, to enable redistribution of RIP and static IP routes into OSPF, enter the following
commands.
device(config)# router ospf
device(config-ospf-router)# redistribute rip
OSPFv2
272 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04