Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 140)

CLI display of IP forwarding cache - Layer 3 switch (Continued) TABLE 24
Field Description
MAC The MAC address of the destination.
NOTE
If the entry is type U (indicating that the destination is this Brocade device), the address consists of
zeroes.
Type The type of host entry, which can be one or more of the following:
• D - Dynamic
• P - Permanent
• F - Forward
• U - Us
• C - Complex Filter
• W - Wait ARP
• I - ICMP Deny
• K - Drop
• R - Fragment
• S - Snap Encap
Port The port through which this device reaches the destination. For destinations that are located on this
device, the port number is shown as "n/a".
VLAN Indicates the VLANs the listed port is in.
Pri The QoS priority of the port or VLAN.
Displaying the IP route table
To display the IP route table, enter the show ip route command at any CLI level.
device# show ip route
Total number of IP routes: 514
Start index: 1 B:BGP D:Connected R:RIP S:Static O:OSPF *:Candidate default
Destination NetMask Gateway Port Cost Type
10.1.0.0 255.255.0.0
10.1.1.2 1/1 2 R
10.2.0.0 255.255.0.0
10.1.1.2 1/1 2 R
10.3.0.0 255.255.0.0
10.1.1.2 1/1 2 R
10.4.0.0 255.255.0.0
10.1.1.2 1/1 2 R
10.5.0.0 255.255.0.0
10.1.1.2 1/1 2 R
10.6.0.0 255.255.0.0
10.1.1.2 1/1 2 R
10.7.0.0 255.255.0.0
10.1.1.2 1/1 2 R
10.8.0.0 255.255.0.0
10.1.1.2 1/1 2 R
10.9.0.0 255.255.0.0
10.1.1.2 1/1 2 R
10.10.0.0 255.255.0.0
10.1.1.2 1/1 2 S
Displaying the IP route table
140 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04