Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 147)

CLI display of global IP configuration information - Layer 2 switch TABLE 27
Field Description
IP configuration
Switch IP address The management IP address configured on the Layer 2 switch. Specify this address for
Telnet access.
Subnet mask The subnet mask for the management IP address.
Default router address The address of the default gateway, if you specified one.
Most recent TFTP access
TFTP server address The IP address of the most-recently contacted TFTP server, if the switch has contacted a
TFTP server since the last time the software was reloaded or the switch was rebooted.
Configuration filename The name under which the Layer 2 switch startup-config file was uploaded or downloaded
during the most recent TFTP access.
Image filename The name of the Layer 2 switch flash image (system software file) that was uploaded or
downloaded during the most recent TFTP access.
Displaying ARP entries
To display the entries the Layer 2 switch has placed in its ARP cache, enter the show arp command
from any level of the CLI. This command shows the total number of ARPs for the default VRF instance.
NOTE
To display the ARP maximum capacity for your device, enter the show default values command.
device# show arp
Total Arp Entries : 1
No.
1 IP Mac Port Age VlanId
192.168.1.170 0000.0011.d042 7 0 1
Syntax: show arp
CLI display of ARP cache TABLE 28
Syntax: show arp
Field
Description
Total ARP Entries The number of entries in the ARP cache.
IP The IP address of the device.
Displaying ARP entries
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 147
53-1003087-04