Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 161)

The following example shows the creation and deployment of a dynamic LAG
that is used for routing on a FastIron device with Layer 3 image.
Brocade(config)# lag “brocade-LAG” dynamic id 55
Brocade(config-lag- brocade-LAG)# ports ethernet 1/1/1 ethernet 2/1/3 ethernet 3/1/4
ethernet 4/1/4
Brocade(config-lag- brocade-LAG)# primary-port 4/1/4
Brocade(config-lag- brocade-LAG)# deploy
Brocade(config-lag- brocade-LAG)# exit
Brocade(config)# interface ethernet 4/1/4
Brocade(config-if-e1000-4/1/4)# route-only
Brocade(config-if-e1000-4/1/4)# ip address 25.0.0.2/24
Layer 3 Routing Protocols
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 161
53-1003087-04