Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 301)

Displaying OSPF interface information
To display OSPF interface information, enter the following command at any CLI level.
device# show ip ospf interface ethernet 1/11
Ethernet 1/11 admin up, oper up
IP Address 15.1.1.15, Area 0
Database Filter: Not Configured
State active(default passive), Pri 1, Cost 1, Options 2,Type broadcast Events 2
Timers(sec): Transmit 1, Retrans 5, Hello 10, Dead 40
DR: Router ID 192.168.254.1 Interface Address 15.1.1.1
BDR: Router ID 10.0.0.15 Interface Address 15.1.1.15
Neighbor Count = 1, Adjacent Neighbor Count= 1
Neighbor: 15.1.1.1 (DR)
Authentication-Key: None
MD5 Authentication: Key None, Key-Id None, Auth-change-wait-time 300
If you specify an interface that is not configured within a specified VRF, then the following error
message will display as shown in the example below:
device# show ip ospf vrf one interface ethernet 1/1
Error: Interface(eth 1/1) not part of VRF(one)
NOTE
You cannot display multiple ports for any interfaces. For example, when displaying OSPF interface
information on ethernet 1/1 only one port can displayed at a given time.
Syntax: show ip ospf [ vrf vrf-name ] interface [ ip-addr ] [ brief ] [ ethernet port | loopback number |
tunnel number | ve number ]
The vrf vrf-name parameter displays information for VRF, or a specific vrf-name.
The ip-addr parameter displays the OSPF interface information for the specified IP address.
The brief parameter displays interface information in the brief mode.
The ethernet, loopback, tunnel, and ve parameters specify the interface for which to display
information. If you specify an Ethernet interface, you can also specify the port number associated with
the interface. If you specify a loopback, tunnel, or VE interface, you can also specify the number
associated with the interface.
show ip ospf interface output descriptions TABLE 60
This field Displays
Interface The type of interface type and the port number or number of the interface.
IP Address The IP address of the interface.
Area The OSPF area configured on the interface
Database Filter The router’s configuration for blocking outbound LSAs on an OSPF interface.
If Not Configured is displayed, there is no outbound LSA filter configured. This is the default
condition.
Displaying OSPF interface information
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 301
53-1003087-04