Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 555)

LOCAL_PREF: 100, MED: 0, ORIGIN: incomplete, Weight: 0
AS_PATH: 100
Syntax: show ipv6 bgp filtered-routes detail [ ipv6-prefix/prefix-length [ longer-prefixes ] | [ as-path-
access-list name ] | [ prefix-list name ]
The ipv6-prefix and prefix-length parameters display the specified IPv6 prefix of the destination network
only. You must specify the ipv6-prefix parameter in hexadecimal using 16-bit values between colons as
documented in RFC 2373. You must specify the prefix-length parameter as a decimal value. A slash
mark (/) must follow the ipv6-prefix parameter and precede the prefix-length parameter.
The longer-prefixes keyword allows you to display routes that match a specified or longer IPv6 prefix.
For example, if you specify 2001:db8::/16 longer-prefixes , then all routes with the prefix
2001:db8::/16 or that have a longer prefix (such as 2001:db8:e016::/32) are displayed.
The as-path-access-list name parameter specifies an AS-path ACL. Only the routes permitted by the
AS-path ACL are displayed.
The prefix-list name parameter specifies an IPv6 prefix list. Only the routes permitted by the prefix list
are displayed.
This display shows the following information.
show ipv6 bgp filtered-routes detail output descriptions TABLE 110
This field... Displays...
Status codes A list of the characters the display uses to indicate the route’s status. The Status field display
an "F" for each filtered route.
Prefix For information about this field, refer to Displaying filtered-out BGP4+ routes .
Status For information about this field, refer to Displaying filtered-out BGP4+ routes .
Age The age of the route, in seconds.
Next hop For information about this field, refer to Displaying filtered-out BGP4+ routes .
Learned from peer The IPv6 address of the neighbor from which this route is learned. "Local Router" indicates that
the device itself learned the route.
Local pref For information about this field, refer to Displaying filtered-out BGP4+ routes .
MED The value of the advertised route’s MED attribute. If the route does not have a metric, this field
is blank.
Configuring BGP4+
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 555
53-1003087-04