Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 230)

The timeout-timer parameter sets the amount of time after which a route is considered unreachable.
The possible value ranges from 9 - 65535. The default is 180 seconds.
The hold-down-timer parameter sets the amount of time during which information about other paths is
ignored. The possible value ranges from 0 - 65535. The default is 180 seconds.
The garbage-collection-timer sets the amount of time after which a route is removed from the rip
routing table. The possible value ranges from 0 - 65535. The default is 120 seconds.
Displaying RIP Information
To display RIP filters, enter the following command at any CLI level.
device# show ip rip
RIP Summary
Default port 520
Administrative distance is 120
Updates every 30 seconds, expire after 180
Holddown lasts 180 seconds, garbage collect after 120
Last broadcast 29, Next Update 27
Need trigger update 0, Next trigger broadcast 1
Minimum update interval 25, Max update Offset 5
Split horizon is on; poison reverse is off
Import metric 1
Prefix List, Inbound : block_223
Prefix List, Outbound : block_223
Route-map, Inbound : Not set
Route-map, Outbound : Not set
Redistribute: CONNECTED Metric : 0 Routemap : Not Set
No Neighbors are configured in RIP Neighbor Filter Table
Syntax: show ip rip
CLI display of neighbor filter information TABLE 51
Field. Defiinition
RIP Summary area Shows the current configuration of RIP on the device.
Static metric Shows the static metric configuration. ".not defined" means the route map has not been
distributed.
OSPF metric Shows what OSPF route map has been applied.
Neighbor Filter Table area
Index The filter number. You assign this number when you configure the filter.
Displaying RIP Information
230 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04