Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 553)

colons as documented in RFC 2373. You must specify the prefix-length parameter as a decimal value.
A slash mark (/) must follow the ipv6-prefix parameter and precede the prefix-length parameter.
The longer-prefixes keyword allows you to display routes that match a specified or longer IPv6 prefix.
For example, if you specify 2001:db8::/16 longer-prefixes , then all routes with the prefix
2001:db8::/16 or that have a longer prefix (such as 2001:db8::/32) are displayed.
The as-path-access-list name parameter specifies an AS-path ACL. Specify an ACL name. Only the
routes permitted by the AS-path ACL are displayed.
The prefix-list name parameter specifies an IPv6 prefix list. Only the routes permitted by the prefix list
are displayed.
show ipv6 bgp filtered-routes output descriptions TABLE 109
This field... Displays...
Number of
BGP4+ Routes
matching display
condition The number of routes that matched the display parameters you entered. This is the number of
routes displayed by the command.
Status codes A list of the characters the display uses to indicate the route’s status. The status code appears
in the left column of the display, to the left of each route. The status codes are described in the
command’s output. The status column displays an "IF" for each filtered route.
Prefix The network address and prefix.
Next Hop The next-hop router for reaching the network from the device.
MED The value of the route’s MED attribute. If the route does not have a metric, this field is blank.
LocPrf The degree of preference for this route relative to other routes in the local AS. When the BGP4+
algorithm compares routes on the basis of local preferences, the route with the higher local
preference is chosen. The preference can have a value from 0 - 4294967295.
Weight The value that this device associates with routes from a specific neighbor. For example, if the
receives routes to the same destination from two BGP4+ neighbors, the prefers the route from
the neighbor with the larger weight.
Configuring BGP4+
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 553
53-1003087-04