Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 232)

ip ospf area 0
ip ospf priority 0
ip rip v2-only
ip address 10.1.1.2/24
ipv6 address 2000::1/32
ipv6 enable
!
To display current running configuration for ve 10, enter the following command.
device#show running-config interface ve 10
interface ve 10
bfd interval 50 min-rx 50 multiplier 3
ip ospf area 2
ip rip v1-compatible-v2
ip rip poison-reverse
ip address 10.1.0.1/24
ipv6 address 2001:db8:1::14/64
!
To display current running configuration for ve 20, enter the following command.
device#show running-config interface ve 20
interface ve 20
ip ospf area 1
ip rip v1-only
ip rip poison-reverse
ip address 10.2.0.1/24
!
Displaying CPU utilization statistics
You can display CPU utilization statistics for RIP and other IP protocols. To display CPU utilization
statistics for RIP, enter the show cpu-utilization tasks command at any level of the CLI.
device#show cpu-utilization tasks
Current total CPU utilization = 89%
... Usage average for all tasks in the last 1 second ...
==========================================================
Name %
idle 11
con 0
mon 0
flash 0
dbg 0
boot 0
main 0
stkKeepAliveTsk 0
keygen 0
itc 0
poeFwdfsm 0
tmr 0
scp 0
appl 89
snms 0
rtm 0
rtm6 0
rip 0
bgp 0
bgp_io 0
(Output truncated)
Syntax: show cpu-utilization tasks
The command lists the usage statistics for the previous five-second, one-minute, five-minute, and
fifteen-minute intervals.
Displaying CPU utilization statistics
232 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04