Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 361)

MTYPE_OSPF6_OTHER 0 0 0 0
MTYPE_THREAD_MASTER 84 1 1 0
Syntax: show ipv6 ospf memory
show ipv6 ospf memory output descriptions TABLE 77
This field Displays
Total Dynamic Memory Allocated A summary of the amount of dynamic memory allocated, in bytes, to OSPFv3.
Memory Type The type of memory used by OSPFv3. (This information is for use by Brocade
technical support in case of a problem.)
Size The size of a memory type.
Allocated The amount of memory currently allocated to a memory type.
Max-alloc The maximum amount of memory that was allocated to a memory type.
Alloc-Fails The number of times an attempt to allocate memory to a memory type failed.
Global memory pool for all
instances A summary of the amount of memory allocated from heap.
Displaying OSPFv3 neighbor information
You can display a summary of OSPFv3 neighbor information for the device or detailed information
about a specified neighbor.
To display a summary of OSPFv3 neighbor information for the device, enter the following command at
any CLI level.
device# show ipv6 ospf neighbor
Total number of neighbors in all states: 2
Number of neighbors in state Full : 2
RouterID Pri State DR BDR Interface [State]
192.168.98.111 1 Full 192.168.98.111 192.168.98.213 e 4/3/1 [BDR]
192.168.98.111 1 Full 192.168.98.111 192.168.98.213 ve 17 [BDR]
Syntax: show ipv6 ospf neighbor [router-id ipv4-address]
The router-id ipv4-address parameter displays only the neighbor entries for the specified router.
show ipv6 ospf neighbor output descriptions TABLE 78
Field Description
Router ID The IPv4 address of the neighbor. By default, the router ID is the IPv4 address configured on the
lowest numbered loopback interface. If the device does not have a loopback interface, the default
router ID is the lowest numbered IPv4 address configured on the device.
Pri The OSPFv3 priority of the neighbor. The priority is used during election of the DR and BDR.
Displaying OSPFv3 neighbor information
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 361
53-1003087-04