Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 169)

IPv6 CLI command support (Continued) TABLE 31
IPv6 command Description Switch code Router code
clear ipv6 route Deletes all dynamic entries in the IPv6 route table. X
clear ipv6 traffic Resets all IPv6 packet counters. X X
clear ipv6 tunnel Clears statistics for IPv6 tunnels X
copy tftp Downloads a copy of a Brocade software image from a
TFTP server into the system flash using IPv6. X X
debug ipv6 Displays IPv6 debug information. X X
ipv6 access-class Configures access control for IPv6 management traffic. X X
ipv6 access-list Configures an IPv6 access control list for IPv6 access
control. X X
ipv6 address Configures an IPv6 address on an interface (router) or
globally (switch) X X
ipv6 debug Enables IPv6 debugging. X X
ipv6 dns domain-name Configures an IPv6 domain name. X X
ipv6 dns server-address Configures an IPv6 DNS server address. X X
ipv6 enable Enables IPv6 on an interface. X X
ipv6 hop-limit Sets the IPv6 hop limit. X
ipv6 icmp Configures IPv6 ICMP parameters X
Ipv6 load-sharing Enables IPv6 load sharing X
Ipv6 mld-snooping Configures MLD snooping X X
ipv6 mtu Configures the maximum length of an IPv6 packet that
can be transmitted on a particular interface. X
ipv6 nd Configures neighbor discovery. X
ipv6 neighbor Maps a static IPv6 address to a MAC address in the IPv6
neighbor table. X
ipv6 ospf Configures OSPF V3 parameters on an interface. X
ipv6 prefix-list Builds an IPv6 prefix list. X
ipv6 redirects Enables the sending of ICMP redirect messages on an
interface. X
ipv6 rip Configures RIPng parameters on an interface X
IPv6 Configuration on FastIron X Series, FCX, and ICX Series Switches
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 169
53-1003087-04