Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 563)

show ipv6 bgp neighbor output descriptions (Continued) TABLE 112
This field... Displays...
Notification Received See above.
Neighbor NLRI
Negotiation The state of the device’s NLRI negotiation with the neighbor. The states can include the
following:
• Peer negotiated IPv6 unicast capability.
• Peer configured for IPv6 unicast routes.
• Peer negotiated IPv4 unicast capability.
• Peer negotiated IPv4 multicast capability.
TCP Connection state The state of the connection with the neighbor. The connection can have one of the
following states:
• LISTEN - Waiting for a connection request.
• SYN-SENT - Waiting for a matching connection request after having sent a
connection request.
• SYN-RECEIVED - Waiting for a confirming connection request acknowledgment
after having both received and sent a connection request.
• ESTABLISHED - Data can be sent and received over the connection. This is the
normal operational state of the connection.
• FIN-WAIT-1 - Waiting for a connection termination request from the remote TCP, or
an acknowledgment of the connection termination request previously sent.
• FIN-WAIT-2 - Waiting for a connection termination request from the remote TCP.
• CLOSE-WAIT - Waiting for a connection termination request from the local user.
• CLOSING - Waiting for a connection termination request acknowledgment from the
remote TCP.
• LAST-ACK - Waiting for an acknowledgment of the connection termination request
previously sent to the remote TCP (which includes an acknowledgment of its
connection termination request).
• TIME-WAIT - Waiting for enough time to pass to be sure the remote TCP received
the acknowledgment of its connection termination request.
• CLOSED - There is no connection state.
Maximum segment size Shows the TCP maximum segment size.
TTL check Shows the TCP TTL check .
Byte Sent The number of bytes sent.
Byte Received The number of bytes received.
Local host The IPv6 address of the device.
Local port The TCP port the Brocade device is using for the BGP4+ TCP session with the
neighbor.
Remote host The IPv6 address of the neighbor.
Remote port The TCP port the neighbor is using for the BGP4+ TCP session with the device.
Configuring BGP4+
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 563
53-1003087-04