beautypg.com

Basic ip configuration – Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide User Manual

Page 22

background image

Feature

ICX 6430

ICX 6450

FCX

ICX 6610

ICX 6650

FSX 800
FSX 1600

ICX 7750

GRE tunnel counters enhancement

No

No

08.0.01

No

08.0.01

No

08.0.10

Routing for directly connected IP
subnets

No

08.0.01

08.0.01

08.0.01

08.0.01

08.0.01

08.0.10

Virtual Interfaces: Up to 512 virtual
interfaces

No

08.0.01

2

08.0.01

08.0.01

08.0.01

08.0.01

08.0.10

31-bit subnet mask on point-to-point
networks

No

08.0.01

08.0.01

08.0.01

08.0.01

08.0.01

08.0.10

Address Resolution Protocol (ARP)

No

08.0.01

08.0.01

08.0.01

08.0.01

08.0.01

08.0.10

Reverse Address Resolution Protocol
(RARP)

No

08.0.01

08.0.01

08.0.01

08.0.01

08.0.01

08.0.10

IP follow

No

08.0.01

08.0.01

08.0.01

08.0.01

08.0.01

08.0.10

Proxy ARP

No

08.0.01

08.0.01

08.0.01

08.0.01

08.0.01

08.0.10

Local proxy ARP

No

08.0.01

08.0.01

08.0.01

08.0.01

08.0.01

08.0.10

Learning Gratuitous ARP

No

08.0.01

08.0.01

08.0.01

08.0.01

08.0.01

08.0.10

Jumbo frames: Up to 10,200 bytes

08.0.01

08.0.01

08.0.01

08.0.01

08.0.01

08.0.01

08.0.10

IP MTU (individual port setting)

No

08.0.01

08.0.01

08.0.01

08.0.01

08.0.01

08.0.10

Path MTU discovery

No

No

08.0.01

08.0.01

08.0.01

08.0.01

08.0.10

ICMP Router Discovery Protocol (IRDP)

No

08.0.01

08.0.01

08.0.01

08.0.01

08.0.01

08.0.10

Domain Name Server (DNS) resolver

08.0.01

08.0.01

08.0.01

08.0.01

08.0.01

08.0.01

08.0.10

IP checksum check disable

No

No

No

No

08.0.01

08.0.01

08.0.10

NOTE
References to chassis-based Layer 3 switches apply to the FSX 800 and FSX 1600.

NOTE
The terms Layer 3 Switch and router are used interchangeably in this chapter and mean the same.

Basic IP configuration

IP is enabled by default. Basic configuration consists of adding IP addresses for Layer 3 switches,
enabling a route exchange protocol, such as the Routing Information Protocol (RIP).

If you are configuring a Layer 3 switch, refer to

Configuring IP addresses

on page 38 to add IP

addresses, then enable and configure the route exchange protocols, as described in other chapters of
this guide.

2

Up to 255 virtual interfaces.

Basic IP configuration

22

FastIron Ethernet Switch Layer 3 Routing Configuration Guide

53-1003087-04