Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 487)

show ip bgp neighbor output descriptions (Continued) TABLE 97
This field Displays.
Multihop-EBGP Whether this option is enabled for the neighbor.
RouteReflectorClient Whether this option is enabled for the neighbor.
SendCommunity Whether this option is enabled for the neighbor.
NextHopSelf Whether this option is enabled for the neighbor.
DefaultOriginate Whether this option is enabled for the neighbor.
MaximumPrefixLimit Maximum number of prefixes the device will accept from this neighbor.
RemovePrivateAs Whether this option is enabled for the neighbor.
RefreshCapability Whether this device has received confirmation from the neighbor that the
neighbor supports the dynamic refresh capability.
CooperativeFilteringCapability Whether the neighbor is enabled for cooperative route filtering.
Distribute-list Lists the distribute list parameters, if configured.
Filter-list Lists the filter list parameters, if configured.
Prefix-list Lists the prefix list parameters, if configured.
Route-map Lists the route map parameters, if configured.
Messages Sent The number of messages this device has sent to the neighbor. The display
shows statistics for the following message types:
• Open
• Update
• KeepAlive
• Notification
• Refresh-Req
Messages Received The number of messages this device has received from the neighbor. The
message types are the same as for the Message Sent field.
Last Update Time Lists the last time updates were sent and received for the following:
• NLRIs
• Withdraws
Configuring BGP4 (IPv4)
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 487
53-1003087-04