Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 295)

NOTE
The hold time values that you specify are rounded up to the next highest 100 ms value. For example,
any value between 0 and 99 will be configured as 100 ms.
Command replacement
This command overlaps in functionality with the timer throttle spf command which will be phased out. To
use this command to replicate the exact functionality of the timer throttle spf command configure it as
shown in the following.
device(config-ospf-router)# timer throttle spf 1000 5000 5000
Displaying OSPF Router Advertisement
Using the show ip ospf command you can display the current OSPF Router Advertisement
configuration.
device# show ip ospf
OSPF Version Version 2
Router Id 192.168.98.213
ASBR Status Yes
ABR Status Yes (1)
Redistribute Ext Routes from Connected RIP
Initial SPF schedule delay 0 (msecs)
Minimum hold time for SPFs 0 (msecs)
Maximum hold time for SPFs 0 (msecs)
External LSA Counter 2
External LSA Checksum Sum 000104fc
Originate New LSA Counter 737
Rx New LSA Counter 1591
External LSA Limit 6990506
Database Overflow Interval 0
Database Overflow State : NOT OVERFLOWED
RFC 1583 Compatibility : Enabled
NSSA Translator: Enabled
Nonstop Routing: Disabled
Graceful Restart: Enabled, timer 120
Graceful Restart Helper: Enabled O 35m5s
Displaying OSPF information
You can display the following OSPF information:
• Trap, area, and interface information
• CPU utilization statistics
• Area information
• Neighbor information
• Interface information
• Route information
• External link state information
• Database Information
• Link state information
• Virtual Neighbor information
• Virtual Link information
Command replacement
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 295
53-1003087-04