Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 616)

lowered by the number specified in the track-port command. When the current priority is lower than
the threshold, the SPF behavior is temporarily suspended and reverts back to the pre-SPF VRRP-E
forwarding behavior. The value range is from 1 through 255.
Displaying short-path forwarding combinations
When short-path forwarding ( SPF) is configured, the output of the following show commands include
the SPF information:
• show run
• show ip vrrp-e brief
• show ip vrrp-e vrid
The following example displays information about VRID 1 when only short-path forwarding is
configured.
device# show ip vrrp-e vrid 1
VRID 1
Interface ethernet v100
state backup
administrative-status enabled
priority 110
current priority 90
hello-interval 1000 msec
dead-interval 0 msec
current dead-interval 3500 msec
preempt-mode true
virtual ip address 10.1.1.3
virtual mac address 0000.0089.7001
advertise backup: disabled
master router 10.1.1.1 expires in 00:00:02.6
track-port 1/13(down)
short-path-forwarding enabled
The following example displays information about VRID 1 when short-path forwarding and revert
priority are configured.
device# show ip vrrp-e vrid 1
VRID 1
Interface ethernet v100
state backup
administrative-status enabled
priority 110
current priority 90
hello-interval 1000 msec
dead-interval 0 msec
current dead-interval 3500 msec
preempt-mode true
virtual ip address 10.1.1.3
virtual mac address 0000.0089.7001
advertise backup: disabled
master router 10.1.1.1 expires in 00:00:02.7
track-port 1/13(down)
short-path-forwarding enabled revertible priority 80 not reverted >
Suppressing default interface-level RA messages on an interface
configured with IPv6 VRRP or VRRP-E
By default, all IPv6-enabled interfaces send IPv6 Router Advertisement (RA) messages. If you
configure an IPv6 VRRP/VRRP-E instance on an interface, the VRRP or VRRP-E instance also sends
its IPv6 RA messages for the virtual IPv6 address on the same interface with the same source
address. An IPv6 host cannot identify the valid IPv6 address for this router interface because of these
two different IPv6 RA messages with the same source address from the same IPv6 router interface.
Displaying short-path forwarding combinations
616 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04