Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 310)

The router-id ip-addr parameter shows the LSAs for the specified OSPF router.
The sequence-number num parameter displays the LSA entries for the specified hexadecimal LSA
sequence number.
The self-originate option shows self-originated LSAs.
show ip ospf database link-state output descriptions TABLE 66
This field Displays
Index ID of the entry
Area ID ID of the OSPF area
Type LS ID Link state type of the route
Adv Rtr ID of the advertised route
Seq(Hex) The sequence number of the LSA. The OSPF neighbor that sent the LSA stamps the LSA with a
sequence number. This number enables the device and other OSPF routers to determine which LSA
for a given route is the most recent.
Age The age of the LSA in seconds.
Cksum The checksum for the LSA packet. The checksum is based on all the fields in the packet except the
age field. The device uses the checksum to verify that the packet is not corrupted.
SyncState This field indicates whether the synchronization is complete or not.
Displaying OSPF ABR and ASBR information
To display OSPF ABR and ASBR information, enter the following command at any CLI level.
device# show ip ospf border-routers 192.168.98.111
router ID router type next hop router outgoing interface Area
192.168.98.111 ABR 193.213.111.111 4/3/1*8/3/1 0
Syntax: show ip ospf border-routers [ ip-addr ]
The ip-addrip-addr parameter displays the ABR and ASBR entries for the specified IP address.
device# show ip ospf border-routers
router ID router type next hop router outgoing interface Area
1 10.65.12.1 ABR 10.1.49.2 v49 0
1 10.65.12.1 ASBR 10.1.49.2 v49 0
1 10.65.12.1 ABR 10.65.2.251 v201 65
1 10.65.12.1 ASBR 10.65.2.251 v201 65
Syntax: show ip ospf border-routers
show ip ospf border-routersoutput descriptions TABLE 67
This field Displays
(Index) Displayed index number of the border router.
Displaying OSPF ABR and ASBR information
310 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04