Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 622)

current dead-interval 3100 msec
preempt-mode true
virtual ip address 10.201.201.5
virtual mac address 0000.00d7.82c9
advertise backup: enabled
next hello sent in 00:00:00.1
backup router 10.201.201.4 expires in 00:02:45.2
backup router 10.201.201.3 expires in 00:02:47.6
track-port 1/1/25*2/1/24(up)
To display information for an IPv6 VRRP Owner, enter the show ipv6 vrrp command at any level of
the CLI.
device#show ipv6 vrrp
Total number of VRRP routers defined: 25
Interface ethernet v52
auth-type no authentication
VRID 52
state master
administrative-status enabled
version v3
mode owner
priority 255
current priority 255
track-priority 5
hello-interval 1000 msec
ipv6-address 2001:DB8::52:3
virtual mac address 0000-5E00-0103
advertise backup: disabled
next hello sent in 00:00:00.1
backup router 2001:DB8::224:38ff:fec8:5a40 expires in 00:02:03.1
The table shows a description of the output for the show ip vrrp and show ip vrrp-extended
commands.
Output description for VRRP-E detailed information TABLE 128
Field Description
Total number of
VRRP (or VRRP-
Extended) routers
defined The total number of VRIDs configured on this Layer 3 switch.
NOTE
The total applies only to the protocol the Layer 3 switch is running. For example, if the
Layer 3 switch is running VRRP-E, the total applies only to VRRP-E routers.
Interface parameters
Interface The interface on which VRRP, VRRP v3, VRRP-E, or IPv6 VRRP-E is configured. If
VRRP, VRRP v3, VRRP-E, or IPv6 VRRP-E is configured on multiple interfaces,
information for each interface is listed separately.
auth-type The authentication type enabled on the interface.
VRID parameters
VRID The VRID configured on this interface. If multiple VRIDs are configured on the interface,
information for each VRID is listed separately.
VRRP and VRRP-E
622 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04