Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 277)

Router OSPF: Enabled
Nonstop Routing: Disabled
Graceful Restart: Disabled
Graceful Restart Helper: Enabled
Graceful Restart Time: 120
Graceful Restart Notify Time: 0
Redistribution: Disabled
Default OSPF Metric: 50
OSPF Auto-cost Reference Bandwidth: Disabled
Default Passive Interface: Enabled
OSPF Redistribution Metric: Type2
OSPF External LSA Limit: 1447047
OSPF Database Overflow Interval: 0
RFC 1583 Compatibility: Enabled
Router id: 207.95.11.128
Interface State Change Trap: Enabled
Virtual Interface State Change Trap: Enabled
Neighbor State Change Trap: Enabled
Virtual Neighbor State Change Trap: Enabled
Interface Configuration Error Trap: Enabled
Virtual Interface Configuration Error Trap: Enabled
Interface Authentication Failure Trap: Enabled
Virtual Interface Authentication Failure Trap: Enabled
Interface Receive Bad Packet Trap: Enabled
Virtual Interface Receive Bad Packet Trap: Enabled
Interface Retransmit Packet Trap: Disabled
Virtual Interface Retransmit Packet Trap: Disabled
Originate LSA Trap: Disabled
Originate MaxAge LSA Trap: Disabled
Link State Database Overflow Trap: Disabled
Link State Database Approaching Overflow Trap: Disabled
OSPF Area currently defined:
Area-ID Area-Type Cost
0 normal 0
OSPF Interfaces currently defined:
Ethernet Interface: 3/1-3/2
ip ospf md5-authentication-key-activation-wait-time 300
ip ospf cost 0
Syntax: show ip ospf config
Configure default route origination
When the device is an OSPF Autonomous System Boundary Router (ASBR), you can configure it to
automatically generate a default external route into an OSPF routing domain. This feature is called
"default route origination" or "default information origination".
By default, the device does not advertise the default route into the OSPF domain. If you want the device
to advertise the OSPF default route, you must explicitly enable default route origination.
When you enable OSPF default route origination, the device advertises a type 5 default route that is
flooded throughout the AS (except stub areas and NSSAs). In addition, internal NSSA ASBRs advertise
their default routes as translatable type 7 default routes.
The device advertises the default route into OSPF even if OSPF route redistribution is not enabled, and
even if the default route is learned through an IBGP neighbor.
NOTE
The device never advertises the OSPF default route, regardless of other configuration parameters,
unless you explicitly enable default route origination using the following method.
If the device is an ASBR, you can use the "always" option when you enable the default route origination.
The always option causes the ASBR to create and advertise a default route if it does not already have
one configured.
Configure default route origination
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 277
53-1003087-04