Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 170)

IPv6 CLI command support (Continued) TABLE 31
IPv6 command Description Switch code Router code
ipv6 route Configures an IPv6 static route. X
ipv6 router Enables an IPv6 routing protocol. X
ipv6 traffic-filter Applies an IPv6 ACL to an interface. X X
ipv6 unicast-routing Enables IPv6 unicast routing. X
log host ipv6 Configures the IPv6 Syslog server. X X
ping ipv6 Performs an ICMP for IPv6 echo test. X X
show ipv6 Displays some global IPv6 parameters, such IPv6 DNS
server address. X X
show ipv6 access-list Displays configured IPv6 access control lists. X X
show ipv6 cache Displays the IPv6 host cache. X
show ipv6 interface Displays IPv6 information for an interface. X
show ipv6 mld-snooping Displays information about MLD snooping. X X
show ipv6 neighbor Displays the IPv6 neighbor table. X X
show ipv6 ospf Displays information about OSPF V3. X
show ipv6 prefix-lists Displays the configured IPv6 prefix lists. X
show ipv6 rip Displays information about RIPng. X
show ipv6 route Displays IPv6 routes. X
show ipv6 router Displays IPv6 local routers. X
show ipv6 tcp Displays information about IPv6 TCP sessions. X X
show ipv6 traffic Displays IPv6 packet counters. X X
show ipv6 tunnel Displays information about IPv6 tunnels X X
snmp-client ipv6 Restricts SNMP access to a certain IPv6 node. X X
snmp-server host ipv6 Specifies the recipient of SNMP notifications. X X
telnet Enables a Telnet connection from the Brocade device to
a remote IPv6 host using the console. X X
traceroute ipv6 Traces a path from the Brocade device to an IPv6 host. X X
IPv6 Configuration on FastIron X Series, FCX, and ICX Series Switches
170 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04