Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide User Manual
Page 575

The detail keyword displays detailed information about the routes. If you do not specify this parameter,
a summary of the routes displays.
This display shows the following information.
show ipv6 bgp neighbor routes best output descriptions
TABLE 121
This field...
Displays...
Number of
accepted routes
from a specified
neighbor
The number of routes displayed by the command.
Status codes
A list of the characters the display uses to indicate the route’s status. The status code appears
in the Status column of the display. The status codes are described in the command’s output.
Prefix
The route’s prefix.
Next Hop
The next-hop router for reaching the route from the device.
MED
The value of the route’s MED attribute. If the route does not have a metric, this field is blank.
LocPrf
The degree of preference for the route relative to other routes in the local autonomous system.
When the BGP4+ algorithm compares routes on the basis of local preferences, the route with
the higher local preference is chosen. The preference can have a value from 0 - 4294967295.
Weight
The value that this device associates with routes from a specific neighbor. For example, if the
receives routes to the same destination from two BGP4+ neighbors, the prefers the route from
the neighbor with the larger weight.
Configuring BGP4+
FastIron Ethernet Switch Layer 3 Routing Configuration Guide
575
53-1003087-04