Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 298)

show ip ospf config output descriptions (Continued) TABLE 57
Field Description
Area-ID Shows the area ID of the interface.
Area-Type Shows the area type, which can be one of the following:
• nssa
• normal
• stub
Cost Shows the cost of the area.
Ethernet Interface Shows the OSPF interface.
ip ospf md5-authentication-key-
activation-wait-time Shows the wait time of the device until placing a new MD5 key into effect.
ip ospf area Shows the area of the interface.
ip ospf cost Shows the overhead required to send a packet across an interface.
Displaying OSPF area information
To display OSPF area information, enter the following command at any CLI level.
device# show ip ospf area
Indx Area Type Cost SPFR ABR ASBR LSA Chksum(Hex)
1 0.0.0.0 normal 0 1 0 0 1 0000781f
2 10.147.60.0 normal 0 1 0 0 1 0000fee6
3 10.147.80.0 stub 1 1 0 0 2 000181cd
Syntax: show ip ospf area [ area-id ] [ num ]
The area-id parameter shows information for the specified area.
The num parameter identifies the position of the entry number in the area table.
show ip ospf area output descriptions TABLE 58
This field Displays
Index The row number of the entry in the router’s OSPF area table.
Area The area number.
Type The area type, which can be one of the following:
• nssa
• normal
• stub
Cost The area’s cost.
Displaying OSPF area information
298 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04