Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 130)

show ip tunnel traffic output descriptions TABLE 19
Field Description
Tunnel Status Indicates whether the tunnel is up or down. Possible values are:
• Up/Up - The tunnel and line protocol are up.
• Up/Down - The tunnel is up and the line protocol is down.
• Down/Up - The tunnel is down and the line protocol is up.
• Down/Down - The tunnel and line protocol are down.
Packet Received The number of packets received on the tunnel since it was last cleared by the administrator.
Packet Sent The number of packets sent on the tunnel since it was last cleared by the administrator.
KA recv The number of keepalive packets received on the tunnel since it was last cleared by the
administrator.
KA sent The number of keepalive packets sent on the tunnel since it was last cleared by the
administrator.
Displaying multicast protocols and GRE tunneling information
The following show commands display information about multicast protocols and GRE tunnels:
• show ip pim interface
• show ip pim nbr
• show ip pim mcache
• show ip pim flow
• show statistics
• show ip mtu
NOTE
All other show commands that are supported currently for Ethernet, VE, and IP loopback interfaces,
are also supported for tunnel interfaces. To display information for a tunnel interface, specify the
tunnel in the format tn num . For example, show interface tn 1. In some cases, the Ethernet port that
the tunnel is using will be displayed in the format tnnum:eport .
The following shows an example output of the show ip pim interface command.
device# show ip pim interface
Interface e1
PIM Dense: V2
TTL Threshold: 1, Enabled, DR: itself
Local Address: 10.10.10.10
Interface tn1
PIM Dense: V2
TTL Threshold: 1, Enabled, DR: 10.1.1.20 on tn1:e2
Local Address: 10.1.1.10
Neighbor:
10.1.1.20
Syntax:show ip pim interface
The following shows an example output of the show ip pim nbr command.
device# show ip pim nbr
Displaying multicast protocols and GRE tunneling information
130 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04