Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 303)

show ip ospf interface output descriptions (Continued) TABLE 60
This field Displays
Events OSPF Interface Event:
• Interface_Up = 0x00
• Wait_Timer = 0x01
• Backup_Seen = 0x02
• Neighbor_Change = 0x03
• Loop_Indication = 0x04
• Unloop_Indication = 0x05
• Interface_Down = 0x06
• Interface_Passive = 0x07
Timer intervals The interval, in seconds, of the transmit-interval, retransmit-interval, hello-interval, and dead-
interval timers.
DR The router ID (IPv4 address) of the DR.
BDR The router ID (IPv4 address) of the BDR.
Neighbor Count The number of neighbors to which the interface is connected.
Adjacent Neighbor
Count The number of adjacent neighbor routers.
Neighbor: The IP address of the neighbor.
Displaying OSPF interface brief information
The following command displays the OSPF database brief information.
device# show ip ospf interface brief
Number of Interfaces is 1
Interface Area IP Addr/Mask Cost State Nbrs(F/C)
eth 1/2 0 16.1.1.2/24 1 down 0/0
show ip ospf interface brief output descriptions TABLE 61
This field Displays
Interface The interface through which the router is connected to the neighbor.
Area The OSPF Area that the interface is configured in.
IP Addr/Mask The IP address and mask of the interface.
Cost The configured output cost for the interface.
Displaying OSPF interface brief information
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 303
53-1003087-04