beautypg.com

Ospfv3 clear commands, Clearing all ospfv3 data – Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide User Manual

Page 379

background image

Area 1:

Authentication: Not Configured

Interface attached to this area: eth 1/1

Number of Area scoped LSAs is 6

Sum of Area LSAs Checksum is 00046630

Statistics of Area 1:

SPF algorithm executed 3 times

SPF last updated: 302 sec ago

Current SPF node count: 3

Router: 2 Network: 1

Maximum of Hop count to nodes: 2

Global IPv6 Address used by Virtual Links in this area:10:1:1::2

Area 0.0.0.0 :

Authentication: Not Configured

Interface attached to this area: VLink 1

Number of Area scoped LSAs is 6

Sum of Area LSAs Checksum is 0002cc53

Statistics of Area 0.0.0.0:

SPF algorithm executed 3 times

SPF last updated: 302 sec ago

Current SPF node count: 2

Router: 2 Network: 0

Maximum of Hop count to nodes: 1

Syntax: show ipv6 ospf vrf vrf-name [area area-id | virtual-links]

Use the show ipv6 ospf vrf vrf-name neighbor command to display the currently selected neighbor for
use by the Virtual Links in each transit area.

device#show ipv6 ospf vrf red neighbor

Total number of neighbors in all states: 1

Number of neighbors in state Full : 1

Type tx rx tx-byte rx-byte

Unknown 0 0 0 0

Hello 32 32 1276 1280

DbDesc 2 2 116 116

LSReq 1 1 52 52

LSUpdate 2 2 184 200

LSAck 2 2 112 112

OSPF messages dropped,no authentication: 0

Neighbor: State: Full Address: 2001:db8:1::1 Interface: eth 1/1

OSPFv3 clear commands

The following OSPFv3 clear commands are supported.

Clearing all OSPFv3 data

You can use the clear ipv6 ospf all command to clear all OSPF data by disabling and enabling the
OSPFv3 processes as shown in the following.

device# clear ipv6 ospf all

Syntax: clear ipv6 ospf all

OSPFv3 clear commands

FastIron Ethernet Switch Layer 3 Routing Configuration Guide

379

53-1003087-04