Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 579)

show ipv6 bgp neighbor routes-summary output descriptions (Continued) TABLE 123
This field... Displays...
NLRIs Sent in
Update Message The number of NLRIs for new routes the device has sent to this neighbor in UPDATE
messages:
• Withdraws - The number of routes the device has sent to the neighbor to withdraw.
• Replacements - The number of routes the device has sent to the neighbor to replace
routes the neighbor already has.
Peer Out of Memory
Count for Statistics for the times the device has run out of BGP4+ memory for the neighbor during
the current BGP4+ session:
• Receiving Update Messages - The number of times UPDATE messages were
discarded because there was no memory for attribute entries.
• Accepting Routes(NLRI) - The number of NLRIs discarded because there was no
memory for NLRI entries. This count is not included in the Receiving Update Messages
count.
• Attributes - The number of times there was no memory for BGP4+ attribute entries.
• Outbound Routes (RIB-out) - The number of times there was no memory to place a
"best" route into the neighbor's route information base (Adj-RIB-Out) for routes to be
advertised.
• Outbound Routes Holder - For debugging purposes only.
Displaying BGP4+ peer group configuration information
You can display configuration information for all peer groups or a specified peer group configured on a
device.
For example, to display configuration information for a peer group named peer1, enter the following
command at any level of the CLI.
device# show ipv6 bgp peer-group peer_group1
1 BGP peer-group is peer_group1
Address family : IPV4 Unicast
no activate
Address family : IPV4 Multicast
no activate
Address family : IPV6 Unicast
activate
Address family : IPV6 Multicast
no activate
Address family : VPNV4 Unicast
no activate
Address family : L2VPN VPLS
no activate
Members:
IP Address: 2000:400:400:400::3, AS: 65020
Syntax: show ipv6 bgp peer-group [ peer-group-name ]
The display shows only parameters that have values different from their default settings.
Displaying BGP4+ peer group configuration information
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 579
53-1003087-04