Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 353)

OSPFv3 detailed database information fields (Continued) TABLE 73
This field Displays
Metric The cost of using this router interface for outbound traffic.
Interface ID The ID assigned to the router interface.
Neighbor Interface ID The interface ID that the neighboring router has been advertising in hello
packets sent on the attached link.
Neighbor Router ID The router ID (IPv4 address) of the neighboring router that advertised the
route. (By default, the router ID is the IPv4 address configured on the
lowest numbered loopback interface. If the device does not have a
loopback interface, the default router ID is the lowest numbered IPv4
address configured on the device.)
Network LSA (Type 2) (Net) Fields
Options A 24-bit field that enables IPv6 OSPF routers to support the optional
capabilities. When set, the following bits indicate the following:
V6 - The device should be included in IPv6 routing calculations.
E - The device floods AS-external-LSAs as described in RFC 2740.
MC - The device forwards multicast packets as described in RFC 1586.
N - The device handles type 7 LSAs as described in RFC 1584.
R - The originator is an active router.
DC -The device handles demand circuits.
Attached Router The address of the neighboring router that advertised the route.
Inter-Area Prefix LSA (Type 3) (Inap) Fields
Metric The cost of the route.
Prefix Options An 8-bit field describing various capabilities associated with the prefix.
Prefix The IPv6 prefix included in the LSA.
Inter-Area Router LSA (Type 4) (Inar) Fields
OSPFv3
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 353
53-1003087-04