beautypg.com

Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide User Manual

Page 626

background image

dead-interval 0 msec

current dead-interval 3600 msec

preempt-mode true

ip-address 10.1.1.5

virtual mac address 0000.0000.0102

advertise backup: disabled

next hello sent in 00:00:01.0

To display information about the settings configured for a specified IPv6 VRRP VRID, enter the show
ipv6 vrrp vrid
command.

device#show ipv6 vrrp vrid 1

VRID 1

Interface ethernet 5

state backup

administrative-status enabled

version v3

mode non-owner(backup)

priority 100

current priority 100

hello-interval 1000 msec

dead-interval 0 msec

current dead-interval 3000 msec

preempt-mode true

ip-address Layer 3 switch a7a7::1

virtual mac address 0000.0000.0201

advertise backup: enabled

next hello sent in 00:00:38.0

track-port 1/1/5(up)

master router fe80::212:f2ff:fea8:5b00 timer expires in 00:00:02.6

The table shows a description of the output for the show ip vrrp vrid command.

show ip vrrp vrid output description

TABLE 129

Field

Description

VRID

The specified VRID.

Interface

The interface on which VRRP is configured.

State

The Layer 3 switch VRRP state for the VRID. The state can be one of the following:

• Init - The VRID is not enabled (activated). If the state remains Init after you activate the

VRID, make sure that the VRID is also configured on the other routers and that the
routers can communicate with each other.

NOTE
If the state is Init and the mode is incomplete, make sure you have specified the IP address
for the VRID.

• Backup - This Layer 3 switch is a Backup for the VRID.
• Master - This Layer 3 switch is the Master for the VRID.

priority

The configured VRRP priority of this Layer 3 switch for the VRID.

current priority

The current VRRP priority of this Layer 3 switch for the VRID.

track priority

The new VRRP priority that the router receives for this VRID if the interface goes down.

hello interval

How often the Master router sends Hello messages to the Backups.

dead interval

The amount of time a Backup waits for a Hello message from the Master before determining
that the Master is dead.

VRRP and VRRP-E

626

FastIron Ethernet Switch Layer 3 Routing Configuration Guide

53-1003087-04