Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 551)

show ipv6 bgp attribute-entries output descriptions (Continued) TABLE 107
This field... Displays...
AS Path The ASs through which routes with this set of attributes have passed. The local AS is
shown in parentheses.
Address For debugging purposes only.
Hash For debugging purposes only.
Links For debugging purposes only.
Reference Counts For debugging purposes only.
Displaying the BGP4+ running configuration
To view the active BGP4+ configuration information contained in the running configuration without
displaying the entire running configuration, enter the following command at any level of the CLI.
device# show ipv6 bgp config
Current BGP configuration:
router bgp
local-as 65020
default-local-preference 400
neighbor 8.8.8.2 remote-as 65080
neighbor 140.140.140.1 remote-as 65020
neighbor 2001:db8:400:400::3 remote-as 65020
neighbor 2001:db8:400:400::3 soft-reconfiguration inbound
address-family ipv6 unicast
neighbor 2001:db8:400:400::3 activate
neighbor 2001:db8:400:400::3 route-map in bgp_map
exit-address-family
end
Syntax: show ipv6 bgp config
Displaying dampened BGP4+ paths
To display BGP4+ paths that have been dampened (suppressed) by route flap dampening, enter the
following command at any level of the CLI.
device# show ipv6 bgp dampened-paths
Status Code >:best d:damped h:history *:valid
Network From Flaps Since Reuse Path
*d 2001:db8::/13 2001:db8:1::1 1 0 :1 :14 0 :2 :20 100
1002 1000
*d 2001:db8::/16 2001:db8:1::1 1 0 :1 :14 0 :2 :20
100 1002 1000
*d 2001:db8::/14 2001:db8:1::1 1 0 :1 :14 0 :2 :20
100 1002 1000
*d 2001:db8::/15 2000:1:1::1 1 0 :1 :14 0 :2 :20 100
1002 1000
*d 2001:db8:8000::/17 2001:db8:1::1 1 0 :1 :14 0 :2 :20 100 1002 1000
*d 2001:db8:1:17::/64 2001:db8:1::1 1 0 :1 :18 0 :2 :20 100
Syntax: show ipv6 bgp dampened-paths
Displaying the BGP4+ running configuration
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 551
53-1003087-04