Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 564)

show ipv6 bgp neighbor output descriptions (Continued) TABLE 112
This field... Displays...
ISentSeq The initial send sequence number for the session.
SendNext The next sequence number to be sent.
TotUnAck The number of sequence numbers sent by the device that have not been acknowledged
by the neighbor.
TotSent The number of sequence numbers sent to the neighbor.
ReTrans The number of sequence numbers that the device retransmitted because they were not
acknowledged.
UnAckSeq The current acknowledged sequence number.
IRcvSeq The initial receive sequence number for the session.
RcvNext The next sequence number expected from the neighbor.
SendWnd The size of the send window.
TotalRcv The number of sequence numbers received from the neighbor.
DupliRcv The number of duplicate sequence numbers received from the neighbor.
RcvWnd The size of the receive window.
SendQue The number of sequence numbers in the send queue.
RcvQue The number of sequence numbers in the receive queue.
CngstWnd The number of times the window has changed.
Displaying routes advertised to a BGP4+ neighbor
You can display a summary or detailed information about the following:
• All routes a device has advertised to a neighbor.
• A specified route a device has advertised to a neighbor.
For example, to display a summary of all routes a device has advertised to neighbor 2001.db8::110,
enter the following command at any level of the CLI.
device# show ipv6 bgp neighbor 2001:db8::110 advertised-routes
There are 2 routes advertised to neighbor 2001:db8::110
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST E:EBGP I:IBGP L:LOCAL
Prefix Next Hop MED LocPrf Weight Status
1 2001:db8::/32 :: 1 32768 BL
AS_PATH:
2 2001:db8::/16 :: 1 32768 BL
AS_PATH:
Syntax: show ipv6 bgp neighbor ipv6-address advertised-routes [ detail ] ipv6-prefix/prefix-length
Displaying routes advertised to a BGP4+ neighbor
564 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04