Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 273)

device(config-ospf-router)# redistribute static
device(config-ospf-router)# write memory
Modify default metric for redistribution
The default metric is a global parameter that specifies the cost applied to all OSPF routes by default.
The default value is 10. You can assign a cost from 1 - 65535.
NOTE
You also can define the cost on individual interfaces. The interface cost overrides the default cost.
To assign a default metric of 4 to all routes imported into OSPF, enter the following commands.
device(config)# router ospf
device(config-ospf-router)# default-metric 4
Syntax: default-metric value
The value can be from 1 - 15. The default is 10.
Enable route redistribution
NOTE
Do not enable redistribution until you have configured the redistribution route map. Otherwise, you
might accidentally overload the network with routes you did not intend to redistribute.
To enable redistribution of RIP and static IP routes into OSPF, enter the following commands.
device(config)# router ospf
device(config-ospf-router)# redistribute rip
device(config-ospf-router)# redistribute static
device(config-ospf-router)# write memory
Example using a route map
To configure a route map and use it for redistribution of routes into OSPF, enter commands such as the
following.
device(config)# ip route 1.1.0.0 255.255.0.0 10.95.7.30
device(config)# ip route 1.2.0.0 255.255.0.0 10.95.7.30
device(config)# ip route 1.3.0.0 255.255.0.0 10.95.7.30
device(config)# ip route 4.1.0.0 255.255.0.0 10.95.6.30
device(config)# ip route 4.2.0.0 255.255.0.0 10.95.6.30
device(config)# ip route 4.3.0.0 255.255.0.0 10.95.6.30
device(config)# ip route 4.4.0.0 255.255.0.0 10.95.6.30 5
device(config)# route-map abc permit 1
device(config-routemap abc)# match metric 5
device(config-routemap abc)# set metric 8
device(config-routemap abc)# router ospf
device(config-ospf-router)# redistribute static route-map abc
The commands in this example configure some static IP routes, then configure a route map and use the
route map for redistributing static IP routes into OSPF.
The ip route commands configure the static IP routes. The route-map command begins configuration
of a route map called "abc". The number indicates the route map entry (called the "instance") you are
configuring. A route map can contain multiple entries. The software compares routes to the route map
entries in ascending numerical order and stops the comparison once a match is found.
Modify default metric for redistribution
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 273
53-1003087-04