Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 568)

You also can display all the dampened routes by using the show ipv6 bgp dampened-paths
command. For more information, refer to
Displaying dampened BGP4+ paths on page 551.
Displaying last error packet from a BGP4+ neighbor
You can display information about the last packet that contained an error from any of a device’s
neighbors. The displayed information includes the error packet's contents decoded in a human-
readable format.
For example, to display information about the last error packet from any of a device’s neighbors, enter
the following command.
device# show ipv6 bgp neighbor last-packet-with-error
Total number of BGP Neighbors: 67
1 IP Address: 153::2
Last error:
BGP4: 0 bytes hex dump of packet that contains error
2 IP Address: 162::2
Last error:
BGP4: 0 bytes hex dump of packet that contains error
Syntax: show ipv6 bgp neighbor last-packet-with-error
show ipv6 bgp neighbor last-packet-with-error output descriptions TABLE 116
This field... Displays...
Total number of BGP Neighbors The total number of configured neighbors for a device.
Last error The error packet’s contents decoded in a human-readable format or notification
that no packets with an error were received.
Displaying Outbound Route Filters received from a BGP4+ neighbor
You can display the Outbound Route Filters (ORFs) received from a BGP4+ neighbor. This option
applies to cooperative route filtering feature.
For example, to display the ORFs received from neighbor 2001:db8::110, enter the following
command.
device# show ipv6 bgp neighbor 2001:db8::110 received prefix-filter
ip prefix-list 2001:db8::110: 4 entries
seq 5 permit 2001:db8:3::45/16 ge 18 le 28
seq 10 permit 2001:db8::4::88/24
seq 15 permit 2001:db8:5::37/8 le 32
seq 20 permit 2001:db8:6::83/16 ge 18
Syntax: show ipv6 bgp neighbor ipv6-address received prefix-filter
The ipv6-address parameter displays the prefix filter learned from a specified neighbor. You must
specify this address in hexadecimal using 16-bit values between colons as documented in RFC 2373.
Displaying routes received from a BGP4+ neighbor
You can display a summary or detailed route information received in route updates from a specified
BGP4+ neighbor since you enabled the soft reconfiguration feature.
Displaying last error packet from a BGP4+ neighbor
568 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04