Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide User Manual
Page 566
For example, to display details about all routes a device has advertised to neighbor 2001:db8::110,
enter the following command at any level of the CLI..
device# show ipv6 bgp neighbor 2001:db8::110 advertised-routes detail
There are 2 routes advertised to neighbor 2001:db8::110
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST E:EBGP I:IBGP L:LOCAL
1 Prefix: 2001:db8:1::/48, Status: BL, Age: 6d13h28m7s
NEXT_HOP: 2001:db8::106, Learned from Peer: Local Router
LOCAL_PREF: none, MED: 1, ORIGIN: incomplete, Weight: 32768
AS_PATH:
Adj_RIB_out count: 1, Admin distance 190
2 Prefix: 2001:db8::/32, Status: BL, Age: 6d13h31m22s
NEXT_HOP: 2001:db8::106, Learned from Peer: Local Router
LOCAL_PREF: none, MED: 1, ORIGIN: incomplete, Weight: 32768
AS_PATH:
Adj_RIB_out count: 1, Admin distance 190
This display shows the following information.
show ipv6 bgp neighbor advertised-routes detail output descriptions
TABLE 114
This field...
Displays...
Number of BGP4+ Routes
advertised to specified
neighbor (appears only in
display for all routes)
For information about this field, refer to the table above.
Status codes
For information about this field, refer to
Displaying routes advertised to a BGP4+
.
Prefix
For information about this field, refer to the table above.
Status
For information about this field, refer to the table above.
Age
The age of the advertised route, in seconds.
Next Hop
For information about this field, refer to the table above.
Learned from Peer
The IPv6 address of the neighbor from which this route is learned. "Local Router"
indicates that the device itself learned the route.
LOCAL_PREF
For information about this field, refer to the table above.
MED
The value of the advertised route’s MED attribute. If the route does not have a
metric, this field is blank.
Origin
The source of the route information. The origin can be one of the following:
• EGP - The routes with this set of attributes came to BGP4+ through EGP.
• IGP - The routes with this set of attributes came to BGP4+ through IGP.
• INCOMPLETE - The routes came from an origin other than one of the above.
For example, they may have been redistributed from OSPFv3 or RIPng.
When BGP4+ compares multiple routes to a destination to select the best route,
IGP is preferred over EGP and both are preferred over INCOMPLETE.
Weight
For information about this field, refer to the table above.
Configuring BGP4+
566
FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04