Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 231)

CLI display of neighbor filter information (Continued) TABLE 51
Field. Defiinition
Action The action the Brocade device takes for RIP route packets to or from the specified
neighbor:
• deny - If the filter is applied to an interface’s outbound filter group, the filter prevents the
Brocade device from advertising RIP routes to the specified neighbor on that interface.
If the filter is applied to an interface’s inbound filter group, the filter prevents the Brocade
device from receiving RIP updates from the specified neighbor.
• permit - If the filter is applied to an interface’s outbound filter group, the filter allows the
Brocade device to advertise RIP routes to the specified neighbor on that interface. If the
filter is applied to an interface’s inbound filter group, the filter allows the Brocade device
to receive RIP updates from the specified neighbor.
Neighbor IP Address The IP address of the RIP neighbor.
To display RIP filters for a specific interface, enter the following command.
device#show ip rip interface ethernet 1/1/1
Interface e 1/1/1
RIP Mode : Version2 Running: TRUE
Route summarization disabled
Split horizon is on; poison reverse is off
Default routes not accepted
Metric-offset, Inbound 1
Metric-offset, Outbound 0
Prefix List, Inbound : Not set
Prefix List, Outbound : Not set
Route-map, Inbound : Not set
Route-map, Outbound : Not set
RIP Sent/Receive packet statistics:
Sent : Request 2 Response 34047
Received : Total 123473 Request 1 Response 123472 UnRecognised 0
RIP Error packet statistics:
Rejected 0 Version 0 RespFormat 0 AddrFamily 0
Metric 0 ReqFormat 0
Syntax: show ip rip interface ifName
To display RIP route information, enter the following command.
device#show ip rip route
RIP Routing Table - 474 entries:
1.1.1.1/32, from 169.254.30.1, e 1/1/23 (820)
RIP, metric 4, tag 0, timers: aging 13
1.1.2.1/32, from 169.254.50.1, e 1/3/1 (482)
RIP, metric 3, tag 0, timers: aging 42
1.1.6.1/32, from 169.254.100.1, ve 101 (413)
RIP, metric 2, tag 0, timers: aging 42
169.254.40.0/24, from 192.168.1.2, e 1/1/1 (1894)
RIP, metric 3, tag 0, timers: aging 14
169.254.50.0/24, from 192.168.1.2, e 1/1/1 (1895)
RIP, metric 4, tag 0, timers: aging 14
169.254.100.0/24, from 192.168.1.2, e 1/1/1 (2040)
RIP, metric 2, tag 0, timers: aging 14
169.254.101.0/30, from 192.168.1.2, e 1/1/1 (2105)
223.229.32.0/31, from 169.254.50.1, e 1/3/1 (818)
RIP, metric 2, tag 0, timers: aging 21
Syntax: show ip rip route
To display current running configuration for interface 1/20, enter the following command.
device#show running-config interface ethernet 1/20
interface ethernet 1/20
enable
RIP
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 231
53-1003087-04