Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 307)

Done
6 0.0.0.200 Net 192.213.111.213 192.168.98.213 8000002d 1683 0x17bc Done
Syntax: show ip ospf database
show ip ospf databaseoutput descriptions TABLE 63
This field Displays
Index ID of the entry
Area ID ID of the OSPF area
Type Link state type of the route.
LS ID The ID of the link-state advertisement from which the router learned this route.
Adv Rtr ID of the advertised route.
Seq(Hex) The sequence number of the LSA. The OSPF neighbor that sent the LSA stamps the LSA with a
sequence number. This number enables the device and other OSPF routers to determine which LSA
for a given route is the most recent.
Age The age of the LSA in seconds.
Chksum The checksum for the LSA packet. The checksum is based on all the fields in the packet except the
age field. The device uses the checksum to verify that the packet is not corrupted.
SyncState This field indicates whether the synchronization is complete or not.
Displaying OSPF external link state information
To display external link state information, enter the following command at any CLI level.
device#show ip ospf database external-link-state
Index Age LS ID Router Netmask Metric
Flag Fwd Address SyncState
1 591 10.65.13.0 10.65.12.1 ffffff00 8000000a 0000 0.0.0.0
Done
2 591 10.65.16.0 10.65.12.1 ffffff00 8000000a 0000 0.0.0.0
Done
3 591 10.65.14.0 10.65.12.1 ffffff00 8000000a 0000 0.0.0.0
Done
4 591 10.65.17.0 10.65.12.1 ffffff00 8000000a 0000 0.0.0.0
Done
5 592 10.65.12.0 10.65.12.1 ffffff00 8000000a 0000 0.0.0.0
Done
6 592 10.65.15.0 10.65.12.1 ffffff00 8000000a 0000 0.0.0.0
Done
7 592 10.65.18.0 10.65.12.1 ffffff00 8000000a 0000 0.0.0.0 Done
Syntax: show ip ospf database external-link-state [ advertise num | extensive | link-state-id ip-
addr | router-id ip-addr | sequence-number num(Hex) ]
The advertise num parameter displays the hexadecimal data in the specified LSA packet. The num
parameter identifies the LSA packet by its position in the router’s External LSA table. To determine an
LSA packet’s position in the table, enter the show ip ospf external-link-state command to display the
table.
Displaying OSPF external link state information
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 307
53-1003087-04