Brocade FastIron Ethernet Switch Layer 3 Routing Configuration Guide - Manual (Page 631)

Output field descriptions (Continued) TABLE 131
Field Description
TX master adv The number of VRRP or VRRP-E advertisement packets sent by this router for a VRID on a
specific interface. This is the same as the "total number of vrrp/vrrp-extended packets sent"
output of the stat option.
RX backup adv The number of VRRP backup advertisement packets received for a VRID on a specific interface.
This is the same as the "backup advertisements received" output of the stat option.
TX backup adv The number of VRRP backup advertisement packets sent by this router for a VRID on a specific
interface. This is the same as the "backup advertisements sent" output of the stat option.
VR Errors This is the sum of these values:
• rxed arp packet drop count
• rxed ip packet drop count
• rxed vrrp port mismatch count
• rxed vrrp number of ip address mismatch count
• rxed vrrp ip address mismatch count
• rxed vrrp hello interval mismatch count
Port Errors This is the sum of these values:
• rxed vrrp header error count
• rxed vrrp auth error count
• rxed vrrp auth passwd mismatch error count
• rxed vrrp vrid not found error count
Clearing VRRP or VRRP-E statistics
To clear VRRP or VRRP-E statistics, enter the clear ip vrrp-stat command at the Privileged EXEC
level or any configuration level of the CLI.
device#clear ip vrrp-stat
Syntax: clear ip vrrp-stat
To clear IPv6 VRRP v3 or IPv6 VRRP-E v3 statistics, enter the following command at the Privileged
EXEC level or any configuration level of the CLI.
device#clear ipv6 vrrp-stat
Syntax: clear ipv6 vrrp-stat
Configuration examples
The following sections contain the CLI commands for implementing VRRP and VRRP-E configurations.
Clearing VRRP or VRRP-E statistics
FastIron Ethernet Switch Layer 3 Routing Configuration Guide 631
53-1003087-04